I believe Dwight Cody can make your splicer like new: www.cutfilm.com
On Fri, Oct 14, 2011 at 5:29 PM, steve cossman <stevecossman_at_hotmail.com>wrote:
>
> To add another question to this thread...
>
> I have ordered blades in the past, but need replacement springs, so if
> there was someone who does it all, or a one stop shop that would be much
> appreciated.
>
> Thank you
>
> Steve
>
> ------------------------------
> Date: Fri, 14 Oct 2011 13:56:06 -0700
> From: epetrol2_at_yahoo.com
> To: frameworks_at_jonasmekasfilms.com
> Subject: [Frameworks] cleanin / changing blades on catozzo 16mm splicer
>
> hey folks
> any idea how to get at the blades on a 16mm catozzo splicer?
> just took a look at mine & realised they're loaded up with years of gooey
> bits of splice tape, so i'd like to take them out & clean them
> cheers moira
>
> www.moiratierney.net
> www.soluscollective.org
> ------------------------------
> **
>
>
>
> _______________________________________________ FrameWorks mailing list
> FrameWorks_at_jonasmekasfilms.com
> https://mailman-mail5.webfaction.com/listinfo/frameworks
>
> _______________________________________________
> FrameWorks mailing list
> FrameWorks_at_jonasmekasfilms.com
> https://mailman-mail5.webfaction.com/listinfo/frameworks
>
>
--
www.ryanmarino.com
www.imminentfrequencies.com
_______________________________________________
FrameWorks mailing list
FrameWorks_at_jonasmekasfilms.com
https://mailman-mail5.webfaction.com/listinfo/frameworks
Received on Fri Oct 14 2011 - 14:45:39 CDT
